Anchor one end of cutting element to body of QuarterMaster, insert the other end of the cutting element into the through-bore in shaft.
Attach Tip Extension to shaft (do NOT use a socket) and using the Torque Wrench begin tensioning the cutting element.
Continue to tension up to the pre-set torque, hold for 5 - 10 seconds, then release. Continue this cycle until
the cutting element has breached the adhesive bead and the tension is reduced.
You can then spin the Torque Wrench at a faster rate.
Tuck Sheets should be used to protect the vertical edge of the part as the cutting element works it's way under it on the finial cut.
Kit contains the following items:
Tuck Sheets in a Tub (4 - 6.5" and 2 - 18" long) NEW!
One Bobbin of 4X Cutting Element
One Drive Tip Extension (must be used to protect shaft)
FREE while supply last - One Torque Wrench (lifetime warranty) not a standard item for the kit.
Comes to you in a custom foam-lined carrying case.